DS18 8 in Roll Cage Soundbar w/2 PRO-HY8.4B

Features

8" Roll Cage Soundbar with 2 PRO-HY8.4B

The JVOCE8 Roll Cage Pod encloses two of our loudest water-resistant Hybrid Speakers: the PRO-HY8.4B, a high-powered speaker with a high-intensity driver built into its frame! The inclusion of this high-compression horn increases the range of frequencies this speaker reproduces to as high as 20KHz.

The combination of the midrange ferrite motor and tweeter neodymium motor is built specifically to allow them to get louder than your usual tower speakers and perform at a higher rate of efficiency for intense sessions that never end!

The JVOCE8 is designed with extremely durable mold-injected plastic to withstand the worst of the elements and outlast any build it’s installed into. The plastic grill helps protect your Hybrid Speakers and has RGB LEDs strung around the inside for easy mood matching!

These Pro Audio speakers can handle RMS Power of 500W, which is about 4 times more than a traditional pod speaker. Traditional water-resistant speakers have to make sacrifices for loudness and sensitivity to achieve the waterproof rating, whereas the JVOCEs do not.

Mount these speakers almost anywhere with DS18’s highly functional pole clamps for installation onto Roll Bars or Mounting Tubes, or use our Flat Mount for even more mounting options.

Features:

• Two water-resistant extremely loud PRO-HYBRID 8-inch speakers with built-in driver for amazing sound quality and intense volume levels
• Highly durable mold-injected plastic tower box mounted through clamps or with included flat mounts
• Built-in LED RGB (Controlled Through LED-BTC RGB Controller.) 

Technical Specifications:

• Nominal Diameter - Dual 8"
• Nominal Impedance - 4+4 Ohms
• RMS Power Handling - 2 x 250w
• Max Power Handling - 2 x 500w
• Frequency Response - 60Hz-20KHz
• Marine Grade Type - IP65 + UV Protected
• Grill Type - Plastic ABS injected
• Clamps - 2 x Tube Clamp Adjustable (2"3") w/360 Degree Rotation Mounting
• Measurements - 19.44" (W) x 6.41" (D) x 10.11" (H)

In the Box:

• 1 x Jvoce Enclosure with dual PRO-HY8.4B Hybrid Loudspeaker
• 1 x Flat Bracket for Jeep JL roll cage
• 1 x Tube clamp adjustable 2" to 3" diameter
• 1 x 6mm Hex wrench chromed
• 1 x 5mm Hex wrench chromed
• 1 x 4mm Hex wrench chromed
• 1 x NBR pad
• 1 x Safety Rope
• 1 x Thread locker glue
• 1 set of screws and stop washers 

*LED-BTC Sold Separately

Specifications